FULLTONE
SSTE
Solid State Tape Echo

"Updated
Version"
Solid state tape echo just like the original '70s EP-3 tape delay
Real 1/4" tape gives you fat sounding delay
Preamp switch lets you choose between classic EP-3 or Full Range preamps
Nickel-plated steel with all stainless-steel hardware,
Proprietary erase, record, and playback heads designed for long life
All handwired point-to-point audio pathway, All handmade in the U.S.
2-speed operation (with trimmer adjustment)
for a choice between hi-fi or warm vintage sounds
Tone control affecting the repeats only
1/4" jack for "Echo Cancel"allowing you to keep the TTE's
preamp in the signal path
SOLD
FULL-DRIVE
1

Finally
the sound of a late 90s to early 2000s
Full-drive without the boost channel!
Simple as it comes, with Vol., Tone, Drive
& toggle bringing back the Flat-Mids (FM),
Vintage, and the infamous (for assaulting the front end of tube
amps)
Comp-Cut (CC) modes.
Simple True-Bypass switching, 9-18 volt operation.
SOLD
|
Full-Drive
3 / JFet

The
FD3 uses a JFET input & a JFET op-amp,
giving it the most tube-like sound you can get out of a tubeless
pedal.
Along with great sound, these JFET’s give the FD3 an ultra-high
Input impedance which allows the pedal to mate with any type/gain
of pickup and react well to changes in your guitar’s volume
control.
Completely
independent OVERDRIVE and BOOST channels
Buffered Bypass, Dynamic Knobs
SOLD
|
|
CS-MDV-MK
II
Custom
Shop Edition

Exact copy of the
Legendary Vintage 60s Univibes
Volume, Intensity and Speed
Modern / Vintage and Vibrato / Chorus
True Bypass
SOLD
|
SOULBENDER
V2

The
Soul-Bender is based on the legendary Colorsound & Vox Series
III ToneBenders made by Sola-Sound/England in the late '60's that
was used by Beck & Page on much of their circa 1968-70 recordings.
Equipped
with 3 gain-matched germanium transistor for a FAT, searing lead tone,
The Tone control response and range is made more usable and much less
shrill sounding... Full clockwise is SMOOTH sounding.
SOLD
|
CLYDE
WAH

SOLD
|